Permalink to K189
45-Ton Tracked Recovery Trailer
Customers who purchased this item also purchased these quality products from Accurate Armour
Tank Transporter Tie Set#1 WW2/Post War
This 1/35th scale Tank Transporter Tie Down set depicts a typical set of Turnbuckles (Strainers), shackles, chain hooks and clamps and chain, and is used to secure Tanks, other vehicles and heavy machinery loads to the bed of a tank transporter (or civilian) trailer.This set (Set #1) was designed by Rob Tearle and is typical of the type in Allied use during (and shortly after) WW2. The set contains metal chain, resin castings and brass rod plus spares …
CHURCHILL ARV Mk-I
This comprehensive 1/35th scale conversion set by Jon Bottomley & Rob Tearle converts the AFV Club Churchill kit* into the Armoured Recovery Vehicle Mk-I which served in all British WW-2 units equipped with the Churchill tank and variants. British “ARV’s Mk-I” were recovery tugs which carried spares, tools, welding equipment and basic recovery, towing and lifting gear and were always based on the tanks they would work with. …
Pressed Steel panking
The largest 1/35th scale Pressed Steel Planking (PSP) set on the market, and it actually joins properly! This design by Rob Tearle contains 12 scale 9’ sections, and comes with full illustrated instructions …
1/35th Scale RN HARD
The WW-2 Royal Navy ‘HARD’ consisted of pre-cast concrete blocks laid into beaches to form a sloping ramp for the loading and unloading of Tank Landing Craft and for DD Tanks and other amphibious vehicles to drive in and out of the water …
This comprehensive 1/35th scale full kit by Jon Bottomley & Rob Tearle depicts the huge British WW-2 45-Ton Tracked Recovery Trailer which was designed to be used with the Churchill ARV Mk-I or large tracked caterpillar tractors or heavy recovery tractors. Designed by Cranes (Dereham)Ltd. for tank recovery and for transporting very heavy equipment on the beaches for the forthcoming Normandy landings this trailer weighs in at 30 Tons unladen.
They were famously used in Normandy to move Locomotives from beached LCT(4) Landing Craft to the nearest rail line. The production of 100 units was undertaken by Boulton & Paul, and they were known as “Orolos” due to the use of the unusual track units of that name rather than wheels. An engine and winch housing with operators compartment is situated on the front deck, with massive loading ramps to the rear.
Our kit comes complete with Scammell winch, detailed drivers compartment, easy to assemble track units, opening stowage lockers, deck fittings and recovery chains, tie downs and winch cable. Etched brass details and a selection of decal markings are also supplied.
The completed model is 13”(330mm) long (ramps UP), 3.5”(89mm) wide and 3.5”(89mm) high.